หมวดสินค้า

หมวดสินค้า

SOZ004 : อะไหล่ชุดผลิตโอนโซน Ozone 40g Inner Enamel Tube Inner Ozone Generator (สั่ง 2 อาทิตย์)

อะไหล่ชุดผลิตโอนโซน Ozone 40g Inner Enamel Tube Inner Ozone Generator (สั่ง 2 อาทิตย์)

>> แจ้งความต้องการสินค้า <<

.  
Dimension:
  • 18g:  233mm  272mm 
  • 30g:  292mm  332mm 
  • 40g:  411mm  450mm
  • 60g:  551mm  590mm 
  • 80g:  656mm  696mm
There are 3 reasons that can cause the damage of the tube, below is the problem and sloving, please read it carefully to prevent any such problems.
  1. the feeding sources is not clean or dry enough. We require pure oxygen, or dry and clean ambient air, with dew temperature -40degree.
  2. The cooling water is not sufficient. (Vertically install the tube, make sure the cooling water go from the bottom to the top, so there is full water in the tube all the time. the cooling water temeperature should be within 8 degree difference compared the working environment temperature, to prevent condensate. Also, please check if cooling water is pure, if too much impurity, it can block the water inlet, so water can go in to cool the electrodes)
  3. There is water back flow into the enamel tube. (When mix ozone with water, make sure using an efficient anti-back flow device, to prevent water back flow, The ozone tube should be placed in a higher position than the water flow, as well.)
  รับประกันสินค้า 3 เดือน

ข้อมูลจำเพาะ

Information on technical characteristics, the delivery set, the country of manufacture and the appearance of the goods is for reference only and is based on the latest information available at the time of publication.
Menu